description document no. 480 7349-001.a00 07/20/15 page 1 specifications *power will vary depending on the sdram used. hx424c15fb/4 4gb 512m x 64-bit ddr4-2400 cl15 288-pin dimm continued >> kingston.com/hyperx features hyperx hx424c15fb/4 is a 512m x 64-bit (4gb) ddr4-2400 cl15 sdram (synchronous dram) 1rx8, memory module, based on eight 512m x 8-bit fbga components per module. each module kit supports intel? extreme memory profiles (intel? xmp) 2.0. each module has been tested to run at ddr4-2400 at a low latency timing of 15-15-15 at 1.2v. additional timing parameters are shown in the plug-n-play (pnp) timing parameters section below. the jedec standard electrical and mechanical specifications are as follows: cl(idd) row cycle time (trcmin) refresh to active/refresh command time (trfcmin) row active time (trasmin) maximum operating power ul rating operating temperature storage temperature 15 cycles 46.75ns(min.) 260ns(min.) 29.125ns(min.) tbd w* 94 v - 0 0 o c to +85 o c -55 o c to +100 o c jedec/xmp timing parameters ? jedec/pnp: ddr4-2400 cl15-15-15 @1.2v ddr4-2133 cl14-14-14 @1.2v ? xmp profile #1: ddr4-2400 cl15-15-15 @1.2v ? power supply: vdd = 1.2v typical ? vddq = 1.2v typical ? vpp - 2.5v typical ? vddspd = 2.2v to 3.6v ? nominal and dynamic on-die termination (odt) for data, strobe, and mask signals ? low-power auto self refresh (lpasr) ? data bus inversion (dbi) for data bus ? on-die vrefdq generation and calibration ? single-rank ? on-board i2 serial presence-detect (spd) eeprom ? 16 internal banks; 4 groups of 4 banks each ? fixed burst chop (bc) of 4 and burst length (bl) of 8 via the mode register set (mrs) ? selectable bc4 or bl8 on-the-fly (otf) ? fly-by topology ? terminated control command and address bus ? height 1.340? (34.04mm), w/heatsink note: the pnp feature offers a range of speed and timing options to support the widest variety of processors and chipsets. your maximum speed will be determined by your bios.
document no. 4807349-001.a00 page 2 continued hyperx for more information, go to www.kingston.com/hyperx kingston.com/hyperx all kingston products are tested to meet our published specifications. some motherboards or system configurations may not opera te at the published hyperx memory speeds and timing settings. kingston does not recommend that any user attempt to run their computers fa ster than the published speed. overclocking or modifying your system timing may result in damage to computer components. module dimensions 3.35 detail e 2.10 module with heat spreader 7.08 mm 133.35 mm 34.04 mm
|
